Industry News

Company News

What are the types and application fields of butter guns

1、 Pneumatic grease gun The working principle of butter guns is roughly the same, and the main difference between different types of butter guns is the difference in power sources. Pneumatic butter guns are suitable for use in lubrication systems and complete sets of butter diversion equipment. The oversized cylinder design improves the oil delivery pressure and oil output, and is suitable for high-viscosity grease, operating in cold regions. It can also be equipped with a mobile electric lubrication device consisting of a mobile trolley, rubber hose, and oil gun, which is dedicated to mobile oil supply using stand-alone equipment with low lubrication frequency, few lubrication points, large oil supply volume, and is not convenient to use centralized lubrication. It is widely used in mines, ports, power plants, production workshops, and other occasions.

What is the working principle of a pneumatic butter machine?

The butter machine is a supercharger designed to inject butter into a lubrication station. Nowadays, with the continuous development of industry, the use of lubricating grease, which plays an important role in machinery, has received considerable attention. There are many types of butter machines on the market, but manual butter machines are more cumbersome to operate. The traditional butter gun that relies on the arm to provide pressure cannot meet the requirements of the times, so people often use non manual butter machines.

What are the precautions for using an electric butter machine?

The electric butter machine is suitable for punching machines, pressure presses, simple plate bending machines, mining machinery, construction machinery, etc. It can be used to adjust intermittent oil supply using microcomputer controlled display, and has a relatively wide range of standby and working time adjustments. Therefore, it is also widely applicable to equipment. 1. When not in use for a long time, the pipeline upstream of the valve should be closed to relieve pressure. 2. When using, the pressure of the oil source should not be too large, and should be kept below 25 MPa. 3. When adjusting the positioning screw, the pressure in the cylinder should be removed, otherwise the screw cannot be rotated.